Gas or Diesel Powered Power Washers

This series can be configured as either Pressure Washers, Steam Cleaners or for Phosphatizing

Gas or Diesel Powered Power Washers

Power Source Engine
Heating Type Oil
Temperature Hot or Cold
Configurations Pressure Washer, Steam Cleaner or Phosphatizing
Flow Rate Up to 15 gpm
Pressure Up to 3,000 psi
Accessories Automatic Shutdown, Remote Control, Rotating Nozzles, Concrete Mowers, Foot Guns & Chemical Injection Options

This series can be configured as either Pressure Washers, Steam Cleaners or for Phosphatizing. The engines are gasoline or diesel with either air or liquid cooling. The engines are sized for continuous operation the heater is fueled by diesel fuel, heating oil or kerosene. Pressure and flow rates up to 15 gpm and pressure up to 3000 psi (custom designs available if requirements are beyond these flows and pressures). Available with a wide range of accessories such as automatic shutdown, remote control, rotating nozzles (TurboLaser), concrete mowers (Pathmaker), foot guns and chemical injection options. Where this equipment is used daily or is important to your operation, be sure to consider the Heavy Duty models and if it is used extensively or is critical to your operation, the Severe Duty models would be recommended.

Typical Oil Heated Pressure Washer Specifications:

In addition to the Engine Driven (Cold)

Heater: Schedule 80 coils, insulated and enclosed in a steel or optional stainless steel jacket, a motor driven burner which is sized to provide a clean burn of the fuel to maximize the efficiency of the heater while to minimize maintenance. The burner is typically DC powered from the engine however belt driven AC generators are also available.

Note the following are for both the Engine Driven (Cold) and the Engine Driven – Oil Heated (Hot and Cold) models.

Download Our Engine Driven Motor Chart (PDF)

Request a Quote